Pinhole Exposure Calculator
Metered exposure time
Ilford HP5 Plus sheet film · ISO 400
—Includes reciprocity correction. Meter at ISO 400 for HP5 Plus at box speed. Other films can differ by more than 10%.
Camera setup
Measure from the pinhole to the film plane.
Film comparison and calculations
Divide the focal length by the pinhole diameter to get the f-number. Square the f-number and divide by 2 raised to the metered EV to get seconds. For an EV reading at ISO 100, multiply the time by 100 ÷ film ISO.
The suggested diameter follows 0.40 mm × √(focal length ÷ 90 mm), rounded to the nearest 0.01 mm. It’s a starting point for balancing diffraction and geometric blur. Use your measured diameter for exposure.
For HP5 Plus, raise the metered seconds to the power of 1.31 above one second. The result is rounded for timing by hand.
The comparison holds the metered time fixed and uses each film’s own correction as the reference. XP2 Super shares the HP5 Plus factor. For films outside this comparison, check the maker’s guide.